OEM 04-13 TOYOTA SIENNA POWER DOOR KEYLESS ENTRY REMOTE FOB TRANMITTER GQ43VT20T

Description

SFfobsinc.
:FOR SALE:
ONE FACTORY TOYOTA
OEM
ORIGINAL KEYLESS ENTRY REMOTE
NO CRACKED OR CHIPPED CASE
NO WORN OFF BUTTONS
REMOTE HAS BEEN TESTED AND IS IN 100% WORKING ORDER
PLEASE READ!!
BUY OEM REMOTE QUALITY AND ONLY HAVE TO BUY ONCE!!
DON'T BE FOOLED BY THE "
LESS EXPENSIVE
" REPLACEMENTS OR CHINA KNOCK OFF'S
THAT WILL ONLY WORK FOR 2 WEEKS AND DIE ON YOU.
BUY OEM QUALITY AND ENDURANCE!!
FCC ID: GQ43VT20T
IC: 1470A-1T
OEM# 89742-02020
4 BUTTON WITH
W/ POWER DOOR
:WORKS WITH:
2004 2005 2006 2007 2008 2009
2010 2011 2012 2013
TOYOTA SIENNA
W/ POWER DOOR
MAY WORK WITH OTHER MODELS AND YEARS.
BE SURE TO CHECK WITH YOUR LOCAL DEALER BEFORE BIDDING
Obtain all remote transmitters for this vehicle.
IF YOUR VEHICLE USES A SMART KEY SYSTEM THEN REMOTE MUST BE PROGRAMMED BY A DEALER OR LOCKSMITH.
This Programming procedure for vehicles without smart key system.
1. Start with the key out of the ignition, drivers door is open, all other doors and trunk closed and drivers door is unlocked.
2. Perform these steps within 5 seconds. A. Insert the key into the ignition (Do NOT Turn it) and Pull key out. B. Insert the key into the ignition (Do NOT Turn it) and Pull key out.
3. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into the ignition (Do NOT Turn it) and Pull key out.
4. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into ignition and leave it in the ignition. D. Close the drivers door. E. Turn the ignition to ON (Do NOT Start or crank engine) then back to OFF. F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not cycle at this point.
6. Perform these steps within 40 seconds. A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds. B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted. C. Repeat steps A and B in step 6 for each new remote.
7. Open drivers door.