-40%
Lexus GS300/400, Toyota Aristo Gauge Pod Vent
$ 15.83
- Description
- Size Guide
Description
GS 300/400/430 Vent Gauge Pod.This 3D printed part goes in the center dash vent. Designed to fit a 52mm or 2 1/16 gauge. This replaces the front part of the vent and still allows control of air flow. Its rotated 20 degrees toward the driver so its right in the drivers peripheral vision. It will work on the left or right vent. This will work on any second generation GS 300,GS400 or GS430. I also make a RHD version of this that fits the 97-05 Toyota Aristo. If you want a RHD version of this please put it in the notes when you purchase or send me a message.
This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim.
Installation is simple. You remove the vent trim and take apart the back of the vent and replace the front with this. No cutting or modifications are required. I designed these with an autometer 52mm gauge which is actually 52.4. If your gauge is too loose add a layer of tape around it until it fits, too tight sand until it fits.
Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many designs for the second generation GS. If your looking for something else check out the rest of my designs.
If you have any questions just ask!