340 TA Mopar Rocker Arm Shafts for Mechanical Rocker Arms - Reconditioned

Description

I have a small block Mopar 340 TA rocker arm shafts for the 340 TA engine cylinder heads. These shafts were cleaned, ground, hard chromed and polished to final size.
New end plugs have been installed.
They feature 2 oiling holes per rocker arm (one in the banana groove on the load side, one for the pushrod cup oiling ).
These shafts are drilled on center for the hold down bolts and have the offset pushrod oiling hole that is needed for the offset intake rocker arms so the intake adjusters and pushrods get proper oiling.
These shafts will provide the proper oiling to high load areas for adjustable iron and aluminum rocker arms to minimize wear and maximize performance and parts life.
Note one shaft has the 5 hold down bolt holes enlarged to allow use of a 3/8 bolt.
These could be used on W2 econo heads that have the pedestals cast into the heads if the hold down holes on one shaft is drilled out to allow a 3/8” bolt.
These shafts are not intended for W2 or W5 heads that use offset drilled blocks to support the shafts
Price is 5 for the pair shipped within the lower 48 states. I can ship internationally for the additional shipping cost.